This chapter describes ISDN Coordinating and Management Entity (CEME) messages. For information on message content and how to use the message, refer to the Introduction.
| CEME.001 |
Level: U-INFO
Short Syntax: CEME.001 START_RQ recvd switch type = switch on isdn/ intf
Long Syntax: CEME.001 Request to initiate L2 for switch switch on network intf
Description: Request to initiate L2 and tei request for this interface
Action: None
| CEME.003 |
Level: U-INFO
Short Syntax: CEME.003 RELEASE Layer 3 prim=0x prim on nt isdn/ intf
Long Syntax: CEME.003 layer 3 Release received primitive=0x prim on ISDN/ intf
Description: Release all the calls for this interface and inform l2
Action: None
| CEME.004 |
Level: U-INFO
Short Syntax: CEME.004 Establish request received, primitive 0x prim on isdn/ intf
Long Syntax: CEME.004 Establish layer 3 primitive value (0x prim) on network intf
Description: Establish layer 3 start D-Channel Communication
Action: None
| CEME.005 |
Level: U-INFO
Short Syntax: CEME.005 TEI tei REMOVED no response from network on isdn/ intf
Long Syntax: CEME.005 tei time out, no network response for tei on isdn intf
Description: Remove TEI
Action: None
| CEME.006 |
Level: U-INFO
Short Syntax: CEME.006 TEI tei REMOVED by request on isdn/ intf
Long Syntax: CEME.006 tei tei has been removed by request on isdn intf
Description: Remove TEI
Action: None
| Panic cemeym |
Short Syntax: YDC ISDN: mem alloc fld
Description: The YDC ISDN network handler failed to allocate sufficient memory during the initialization phase.
Action: Contact customer service.